Direct drive dual gear extruder remix

thingiverse

this is a remix from adevrim's direct drive dual gear extruder mount,i like this one as it allowed me to mount my crtouch and most certainly would allow the bltouch with out getting in the way another version i tried had a way of mounting the got in the way of autobed level mount but, i also had some minor issues with the mount and wiring so i brought it over to fusion 360 took a little out on the extruder side there was an extra piece of plastic that was in my way and where the 2 holes for the sleeves for the wheels are supposed to go into were just a little to far out so i took .5 mm off holes in fusion 360 were on point at 8mm for the sleeves but i found them to be a bit too tight i tried modifying the holes but decided not too, and going to just use some scissors to widen the holes just a little. going to print this next on the ender 3 while the cr10 is busy and hopefully these changes help. let me know if this was of any help.