Direct extruder for tronxy xy2 pro (superfly mod)

thingiverse

Superfly remix for tronxy xy2 pro. For this project you will need a bmg (dual drive) extruder and e3d v6 hotend I tried to achieve maximum rigidity and modularity of the structure. The displacement of the hot end relative to mk8 is minimal and the X and Z axes do not lose their size. The Y-axis will decrease slightly, by about 10mm. There are mounting options for 2 x 4010 turbine fans or 2 x 5015 fans. The distance from the gears of the extruder to the nozzle is about 73mm, which is quite small. A piece of Teflon tube must be installed between the extruder and the hot-end (if the hot-end is for bowden, then the tube length is 3.2-3.3 cm. The table autolevel sensor will change its position relative to the drain, you need to enter new coordinates in the firmware (for mounting with a 5015 rotator for marlin "#define NOZZLE_TO_PROBE_OFFSET {-35, -25, 0}") The hot end attachment point will be slightly damaged, outside, during installation, because the distance between the bolts is less than the diameter of the hot end (see the screenshot). The extruder body is printed at a speed of 30-40mm/s You will need m3, m4 and melt incert nut bolts and 2 m3 nuts to mount the auto level sensor. The screenshots show what and how much. Some parts are better printed with 100% infill for good rigidity (there is also a screenshot). And the mount of the hot end, if possible, print with abs plastic. Also, the screenshots show where the printing support is needed and how the models should be positioned.