Dished Fidget Spinner Caps

thingiverse

I created these for all our spinners because the existing caps I found were either too wide, male/female sets that were a pain or were touching the bearing shields. With these dished caps you can really get a good spin going without risk of dropping the spinner... Print Settings Printer: Hictop 3DP-18 Rafts: No Supports: Yes Resolution: .1 Infill: 50 Notes: Supports set at 10% fill (almost not needed but keeps the edges nicer) .1mm from Z .2mm from x/y sides I printed at .1mm just for the prettiness...they do well at .2 also