DJI Mavic Pro Gimbal Lock/Lens Protector-Polar Pro & Taco ND **NinjaFlex**

thingiverse

This is a combination gimbal lock/lens protector I designed for the DJI Mavic Pro. It installs from the front and utilizes the tabs that the front feet of the gimbal ride above. It must be printed with a flexible material, I used Ninjflex Semiflex (regular NinjaFlex was too flexible). There have been many cases where the small plastic tab on the back of the camera/gimbal breaks in transit where the factory gimbal lock slides in to hold it in place. This is a simple solution that bypasses the need for the factory lock, and it holds the gimbal in place just as well if not better. *UPDATE 4.9.17- I have added designs that will fit over the Polar Pro Cinema series as well as the Taco ND series of filters. There is a "PP" and a "T" on the inside of the lens cap for easy identification. See the video below for installation. Print Settings Printer: FlashForge Creator Pro Rafts: No Supports: No Resolution: High Infill: 100% Notes: If you have printed with flexible material you know that it takes a while to tweak your settings to get it just right, so I'm not going to go into my setup as each printer as well as material used are vastly different. Custom Section