DJI Naza V2, GPS Guard

thingiverse

Created the guard for the DJI Naza V2 GPS sensor so it can stand up to an impact better (hopefully). I also made a stand which is slightly shorter than stock and can break in an impact to reduce the force on the sensor to again help it stand up to an impact. The stand is a separate piece and can be glued to the stand or use double sided tape for extra vibration isolation. This can also be used with the stock Naza GPS stand, just secure it with the double sided tape as you would normally. There are two versions of the guard. the "no_tape" file is if you want to just use the guard, the Naza fits fairly snugly in there. There the "tape" version is 0.25mm bigger inside diameter to allow the use of copper tape inside the guard for noise reduction. Instructions The actual guards can be printed in any layer thickness successfully, I have tried 0.1mm, 0.2mm and 0.3mm, all of which printed just fine. The settings that I used: Black PLA 0.3mm Layer Height 2 Shells 10% infill No Raft or Support The stand used the same print settings except for one. I had to use a 0.2mm layer height because it didn't print the overhang on the top correctly, started getting some stray plastic coming out due to the angle with a 0.3mm layer. If it gives anyone problems with that I can change the angle on it so it isn't quite as steep and will print better.