DJI Phantom iPad Mini Visor and Mount for Otterbox/LifeProof

thingiverse

This is a custom visor/clamp assembly to work with a iPad mini (1, 2 and 3. Not sure it it will work with a 4) in a LifeProof or Otterbox case (Visor base included for both cases). The clamp assembly uses the stock hardware of the remote. It will require a little sanding in the visor base channels to smooth out print lines and make visors slide in and out easily. I also remixed the clamps from eburgess4 located at http://www.thingiverse.com/thing:1738401/#files to be stronger, and adjusted the angle on them to fit the tablet with the visor base. Can't seem to link the remix as the only way I can pull up his work is through Google. But kudos to eburgess4 for the assist! These clamps can be used instead of the replacement tablet mount, for those who want to use the existing DJI setup. The clamps will need some sanding to smooth print lines and allow them to slide on and off more easily. Print Settings Printer: Lulzbot 6 Rafts: Yes Supports: Yes Resolution: High Quality Infill: 20% Notes: Material Used: MatterHackers Pro PLA Because of the several precision measurements, it is recommend printing this at the highest quality possible. Using Lulzbot Cura, I did change the "Fill" thickness (Bottom/Top Thickness) to 7MM when printing the replacement mount to further strengthen where the clamp connects to the controller.