DJI Spark Controller Phone Holder

thingiverse

Hello, This is a phone holder for the DJI Spark controller but may work on the Mavic controller as well. This holder was made using the top part of a cheap selfie stick that my daughter had lying around. Right now I'm using an Iphone 6s and there is a little room left for something slightly bigger. I also add a post for a key ring for use with a lanyard. Printing... Orientation should be printed with posts pointing up No supports needed. I also printed the base with 20% infill and the part of the base under the posts was printed at 100%. Probably doesn't need that much but I would rather spend a couple dollars on filament than have to buy a phone or controller if it were to break. Happy printing and have a great day.