Dji Spark / Mavic phone mount addapter

thingiverse

Simple phone mount for dji spark or mavic remote controller. I use this to have better viewing angle which helps me see a lot better during flight. The tilt angle can be adjusted to your liking This a full print no other parts are required. (Keep in mind that on mavic it will make it harder to see the built in display of the controller) Print Instructions: * 1x 130m-bolt.stl * 1x base.stl * 1x Knob_1.stl * 1x Knob_2.stl * 1x Lower_clip.stl * 1x m8-40mm-bolt.stl * 1x tilt.stl * 3x m8-nut.stl *** NOTE Printing 130m-bolt.stl as provided requires no support but is structurally weak and easy to break, it is recommended to rotate it and print along the x or y axis with support instead. Threaded parts (bolts and nuts) have to be printed with 0.1 - 0.12 layer height, all rest can be printed with 0.2 tilt.st and Knob_1.stl will require support Recommended to print the bolts with minimum 60% infill the rest with at least 15% Post Print: tilt.stl needs to be sanded a little to fit in the base, this is done on purpose and it should not be sanded too much as it has to be a tight fit, if the fit is loose you would have to tighten way too much to hold it in place Assembly: 1. put the lower clip onto the 130mm rod with clip at the end 2. put one nut into knob 1 (maybe glue it in) and screw it to the 130mm rod 3. put one nut into the tilt peise (maybe good to glue it in) 4. screw the 130mm rod onto the tilt, go all the way in then back off to adjust the top stationary clip, so that it is straight and therefor the phone will be facing you when it's attached to the frame. Once put in place glue it in position so it will not move anymore. 5. put the last nut into knob 2 (maybe glue it in)# 6. put the whole tilt assembly onto the base then secure with the 40mm bolt and knob2 m8 bolts and nuts are generated with this thing: https://www.thingiverse.com/thing:193647