DJI Spark Snap-On Propeller Guard

thingiverse

DJI Spark Propeller Protective Guard. This is my second design, easily snaps on and removable without screws. prints in one piece without the need of supports. There are holes at the ends of the guard so that you can connect them with wires for a full 360 protection. I designed this because one of my spark's arm broke near the motor mount. After epoxying it back in place, this prop guard helps hold the weakened parts in place. I designed this with the layer height 0.4mm or 0.6mm in mind. Of course you can print in higher resolution just that it takes a longer print-time. If you like this design please leave a "like" and share your prints :-) Check out my other designs and other cool stuff by clicking on my profile :-) *** FLY RESPONSIBLY! ALWAYS USE A PROP GUARD! NOT JUST FOR THE SAFETY OF YOUR CRAFT BUT FOR THE SAFETY OF THE PEOPLE AROUND YOU *** Enjoy! http://www.KikiTayBlog.com