DL180 Quad camera and LED holder

thingiverse

This is small camera (HS1177 600TVL from surveilzone and similar) holder + LED's in front for DL180 mini-quad: http://www.surveilzone.com/RC-DL180-Full-Carbon-Fiber-Power-Quad-Frame-for-FPV-Racing-g-1454 LED used in front: http://www.banggood.com/1_8W-12led-COB-LED-Chip-130mA-WhiteWarm-White-For-DIY-DC-12V-p-957669.html They are connected via adjustable step-down converter @10V - this way they use ~4W in total and do not overheat (at 12V they are incredibly bright, but will melt PLA in ~15s idle @ room temperature, not in flight). Bright enough for night flying. Rear LED is this one: http://www.banggood.com/6W-6000K-COB-LED-C5W-Festoon-Bulb-No-Error-Number-License-Plate-Light-White-p-1000754.html - unsoldered bridge and it fits nicely, powered from the same SMPS as front LED's. Rear mount also holds OpenLRS MicroRX (there's perfect hole for SMA connector) and has cut-out for power wires. This one is 30mm height (lower than original standoff) to keep CG low. 33mm version soon, will have even more space and will add more space for front HD camera mount (but this version is usable without issues too). Camera angle is adjustable up to ~40°, 33mm version will have even more space. Print Settings Printer: Wanhao i3 Rafts: No Supports: Yes Resolution: 0.2 Infill: 35 Notes: Print with stand-off holes vertical (in other words - as it will be mounted on quad). I used PLA, bed temp. 65°, extruder 200°. Sliced in Simplify3D.