DL24m Electronic Load

thingiverse

There were no enclosures for DL24m module, so I designed one. Front part slides between top and bottom, so it is easy to print and assemble. No supports required, just print it as is. Parts list: 1. DL24m 150W module 2. DC power jack 5.5 x 2.1 (I used metal one from aliexpress) 3. 2 x dual banana binding posts 4. 2 pin JST connector with short wire 5. 4 x M3 screws for the case, 10-15 mm length, 5 mm head diameter 6. 4 x screws for DL24m board (can also use M3, or some other screws for plastic) 7. 4 rubber feet Notes: Looks like this module is designed to work without an enclosure. After some testing, 150W load can only be used for a short period of time because there is 100C temperature sensor protection inside. I would recommend using 120-130W as maximum. Cooler blows air on all four sides, and here front side is blocked.