3 hybrid planks, RC airplanes.

thingiverse

Print the nose for the motor bolt pattern you have and a rear half, Joiner and vertical stab. Typical motors that may fit are the 1806 and 2206 quad motors, a Blue Wonder type motor and a 2212 conventional 50 gram motor. So print a nose tail vertical stab and joiner. The wing is held on with rubber bands. The rear dowel pin also holds in the vertical stab. The wing I used was a 24"x8" kfm1 foam board wing. It has good characteristics for this model. Make the area under the rear two layers to add a bit of stiffness but mainly to make the top surface of the wing flat. With the small motor and smallish battery the plane is under 250 grams With a 50g motor and 2500mah battery it is 380 grams.