DNA250 Squonker "The Ellipse"

thingiverse

Three main body parts, the front, back and door, the door is clip in and the front and back are held together via 4 small screws. This is designed to fit the 1300mAh lipo from the Hcigar VT200, anything bigger will not fit, its a squeeze inside! The 510 hole is 12mm in diameter, to suit the Modmaker MM510. H85*D55.7*W41 UPDATE: Long overdue, but the remaining files have now been added, i have printed the V1 model and use it plenty, but it was a tight fit for the lipo and had some imperfections i was unhappy with. The uploaded files are a from my V2 model in which i tried to correct some of my gripes and make a bit more room for the lipo, so this model is a bit bigger from the front to the back, the height etc are the same still. I have not tested the V2 files in print. H85*D58.78*W41 mm The Top insert is to be placed inside the back body part under the 510 hole, before you add the 510 and earth ring/nut. It is there to add extra support for the 510 area to allow proper tightening and better handling of heat as i print in PLA, and without the part in place, over tightening can crack the body