DnD Hex Grid Props

thingiverse

These hexagonal props were made based on Pocket Tactics hexagonal tile trays. We use a ton of these trays and a few of these props to enhance the fun of dungeons and dragons gameplay. If I make any more props, I will add it here. The props are 26mm diameter (flat side to flat side) while the tray hex spaces are about 26.8mm. Please let me know if you have any prop suggestions, ideas, or improvements in the comments. I would love to see if you printed them! Take a picture and post a make. Check out foolsgambit interlocking pocket tray below:http://www.thingiverse.com/thing:54835 Update 4: Added single, double, and triple hex trays. Update 3: Added Wall lever, Floor Lever, Chest, Orb, Crystal Pedestal, Rotating Mirror, Inside Wall Half, Inside Wall Full, and Rotating Levers Thing. Also renamed stls with Double to Full and Single to Half. Update 2: Added Pressure Plate. Could also be used as a pedestal or anything really. Use your imagination! Update: Large and Medium Tile trays added! Large is 4 pieces and medium is 3 pieces. It should make setting up large landscapes easier. It's a big print so It may not fight your print bed. 218 x 163 mm for large and 156 x 163 mm for medium. Instructions I print these at 12.5% infill to save on plastic. I also print at 0.2mm layer height since it looks better. Some pieces will have support built in, simply break them off. Stls with the word set in them contain multiple pieces.