DnD Miniature Travel Case

prusaprinters

<p>This is a model I designed for my dnd group to hold up to 21, ten to thirty-two mm miniatures. It's designed to be used with a disc spindle, unfortunately I was unable to find the original one I purchased, but the following link should be a good analog: <a href="https://smile.amazon.com/EMPTY-CAKE-SPINDLE-100-DISCS/dp/B0089Y6WPG/ref=dp_prsubs_1?pd_rd_i=B0089Y6WPG&amp;psc=1">disc spindle</a>. &nbsp;This design could however also be used without the protective spindle. &nbsp;The “mini holder core” is a difficult print, it will print better if you set bottom layer lines to alternate by 45 degrees. &nbsp;The “dice holder” can be assembled and will screw into the core. &nbsp;The top of the mini holder screws in via threads and the handle can be press fit and glued into it. &nbsp;Finally, the miniholder clamps can be slid in and out after a bit of cleanup and they will hold miniatures securely when you press fit them to the base, you will need to print 21 of these (there is a thicker and thinner version depending on printing tolerances).</p>