Dobelman D20 of holding

thingiverse

This is not a Remix, but very much inspired by https://www.thingiverse.com/thing:105296 and https://www.thingiverse.com/thing:1610141 Numerical faces are aligned to be used as a countdown die. The Top seam shouldn't snag or over hang when closed. There is a little notch between 16/20 along the edge that should help easily line the lid up. It was also intended to help lift the lid when opening. However i found that sliding the top across the magnets was much better and more gratifying than lifting it straight up. Picked up the magnets from the local Michaels. https://www.michaels.com/promag-neodymium-magnets/10413548.html .25in - 6.3mm Printed with Makergeek Royal Purple ABS. I did have a couple of minor splits in my print. And used a thick ABS slurry as glue to hold the magnets in. Which i have a feeling, since the magnets are so smooth may pop out some day soon. Should have super glue'd em. I'd love to see this printed with a better (or better adjusted) printer.