Dog Biscuit Roller - Paw Print Design

thingiverse

Here's a roller I designed in TinkerCAD for some homemade dog biscuits I like to make. The roller adds a paw print design to the biscuits and helps give a visual guide for cutting straight lines as well. Please print with food safe filament. The roller didn't need to be all that long because I only make so many biscuits at one time. I think it took around three rolls to cover the whole sheet of biscuits with the design imprint. The design allows enough room to make nice cuts above & below as well as on each side of the paw print. The treats I make are for my 25lb & 35lb dogs. You might want to size the roller larger or smaller depending on the size biscuits you would want. I used this recipe for the biscuit mix: https://www.spendwithpennies.com/pumpkin-dog-treat-recipe/print/ It's nice because the mix is thick enough to hold the paw imprint during the bake. This is the my first original creation I'm publishing on Thingiverse! Please post a picture of your print or biscuits if you make it. Treat your pups to some homemade biscuits :) Enjoy!