Dolce Gusto Wall Capsule Dispenser

thingiverse

This is a wall mounted Dolce Gusto capsule dispenser. The wall fixation is intended to be hot glued to avoid making any hole and it is able to hold up to 7 capsules. I designed it to save the maximum filament and printing time. It only requires about 35 grams and two hours to be printed (depending on parameters) which is much less than others found. I also upload three versions with capsule identification in spanish, let me know if you need some other labels and I will try to upload it. It need bed support for the first part as shown in pictures. Without furhter supports some bridging is noticeable but you can sand it or decrease the layer height. My printer settings are: - 0.3 Layer height. - PLA - 60 mm/s of printing speed - Bed supports - 2 walls - 50 % Infill (this won't change the printing speed a lot since it only affects the main column and the bottom plate). Hope you enjoy guys! Regards.