Dominion Box Insert

thingiverse

This design is an insert for dominion, that I can house 4 large expansions/base games in one box. The design is fairly modular so it can be modified as desired. It is extremely important to make sure the printed parts are very flat. If there is any warping, the pieces will not interlock properly. I highly recommend optimizing the print process for one piece. The optimized parameters should work for all the remaining pieces. On my personal printer, a skirt helped quite significantly. In order to create a layout similar to the sample pictures, you will need to print the following: 4 x Piece 1 4 x Piece 2 4 x Piece 3 2 x Piece 4 2 x Piece 5 2 x Piece 6 2 x Piece 7 2 x Piece 8 Pieces 1, 2, and 3 all combine into one long piece (you should end up with 4 long pieces, all the same length and size; make sure to not swap any of these pieces for 4, 5, or 6)(feel free to glue if necessary; on my printer, the joints are tight enough that friction holds them in place). The 4 long pieces from 1, 2, and 3 will form the exterior square of the insert. Pieces 4, 5, and 6 all combine into another long piece. The 2 long pieces from 4, 5, and 6 can be place inside of the framework formed above. This should create three rectangular storage areas. I would recommend place these long pieces such that the two exterior areas are exactly the height of a card. This arrangement will allow you to store 4 expansions in the box (2 on each side) and use the middle section for various cards and pieces. Pieces 7 and 8 can then be used to create further storage areas, separating the long rectangular areas into smaller areas. Depending on the placement of pieces 4, 5, and 6, you may need to modify the dimensions of pieces 7 and 8.