Donkey Car Mounting Frame

thingiverse

This model includes a frame to which a Raspberry Pi, servo controller and camera can be mounted to. Includes mounting points for: - Raspberry Pi Model 3B+ - Raspberry Camera Module V2 - Adafruit 16-Channel 12-bit PWM/Servo Driver (PCA9685) (or components with similar hole placement) Designed for HSP 94186 Brushed RC Car with dimensions 175 x 25 between cover hole centers Brief: - Print volume: 190 x 84 x 25 (main frame) and 86 x 30 x 17 (camera arm). - Maximum bridge is 26mm long (approx. 1 in) - 1mm wall/three perimeters is sufficient - No supports required - 13 M2.5 x 8-10mm bolts, 13 nuts and 2 washers required (3mm ID x 8mm OD) Advantages: - Easy access to SD card from top, power ports from sides - Camera arm pivot - Little material required and fast printing time - Extra batteries can be mounted on top of the main frame - The main frame can be mounted upside down if the camera arm is not required Disadvantages: - Ensure your ribbon cable is long enough (standard Camera Module V2 is acceptable) - Non-conductive spacer (sponge) required to reduce stress on PCB