DoobDock

thingiverse

Attach your cigarette holder for the controller by inserting it into the docking station in the plug and charge port; this allows you to unplug and share it as desired. Required items are a 6-32x12" threaded rod, two 6-32 nuts, and an alligator clip. For optimal performance, set your infill at about 20%, although slightly excessive, it works well. Install support for the bottom hole and print your design. Using a dremel, create holes on the top and bottom, both countersunk, using a 6-32 nut. Due to tightness of the hole, some force is required when inserting the threaded rod. Verify the width of the port is correct, but adjust the sides if necessary for a snug fit. Trim to your desired length and attach alligator clips to the top end. Have fun!