Double Decker Fidget Spinner

thingiverse

This is a derivative of my Minimal In-line Spinner. The "Double Decker" is literally just that, the in-line spinner with another "deck" for two more bearings. Not only does this give it a really cool look, but the extra weight gives you extra spin. This also uses the 608 bearings. The included central peg makes for easy finger spinning or place it on a surface, put your finger on top and spin it like a lunatic. There are two different pegs as I printed a couple of differnet designs to see what worked best and these were both winners. Added files: Double_Decker_R1. I've just knocked the inner corners off the snap pegs to make fitting easier and reduce the risk of breaking them while fitting. I've left the original files for reference. Print Settings Printer: Anet A8 Rafts: No Supports: Yes Resolution: 0.2 Notes: You'll need to print with supports for the spinner body and you might want to use a brim on the central peg, depending on your bed adhesion. The higher your infill %, the stronger it will be of course. I'd suggest at least 40% because of the snaps for the outer bearings. You need to print the body, either of the spinner pegs and two of the peg caps. Post-Printing Remove support material. Carefully snap on the outer bearings, if you're too rough they might break (yes, I broke my first one)! If you have shielded bearings like the outer ones pictured, you will want to make a small modification to the middle one: Remove the shields, clean the bearing thoroughly and then lube with PTFE spray or similar. There are plenty of online tutorials of how to do this. Fitting of the central peg is self-explanatory. My Other Fidget Spinners Pencil Top Fidget SpinnerMinimal Fidget Tri - SpinnerMinimal In-Line Fidget SpinnerSpeedy Car Fidget Spinner