Dragon Fire

prusaprinters

<p>This looks like a 2 foot or approximately 600mm fire coming out when lit from the inside with LEDs. It is good with RGB and better with Individually Addressable 2812 LEDs. To print on a smaller Prusa Mendel, old school printer, I broke it up in sections and glued them together and had the LED strip in the middle and an Arduino Nano for control.</p> <h3>Print instructions</h3><p>Print each section, 1-4. They should be like a series of containers. The left sections are published. To do the right side, just mirror the left sections on your slicer software. Then attach the left sections to each other and then right sections to each other, making 2 fire halves. Then either glue them together or print and use about 12 of the Dragon Fire Clips to secure the halves together while still being able to get inside the fire halves.</p>