Dragon Flight 95 Hatch

thingiverse

Printed hatch for the Dragon Flight 95 RC yacht Just drop into the hatch opening and seal with hatch tape. A lot easier than patches Fitted with a loop, so you can tie it to servo tray on the boat so as you won't forget or loose them. Put the loop on the starboard side to keep it clear of the winch lines. For my DF65 hatches see, https://www.thingiverse.com/thing:1666297 Printed at 0.1mm layer height as it's only 0.5mm thick and this gives at least 3 layers. This helps make sure it's waterproof and still light weight. I used flexible filament because it more forgiving when you peel the hatch tape off.