Drain pipe shelfs

prusaprinters

<p>Small drain pipe shelf (ca.28mm shelf depth). Needs 2 pcs. 6mm bolts and nuts.</p> <p>I'm currently printing a larger shelf (ca 55mm) version (40h job due to its ca. 23 mm bigger than my printbed (200,200), so it needs to stand up in a 40 degree angel, so a lot of support needed :-/</p> <p>If it comes out well ill post it, maby make a 3-4 part version to reduce print time.</p> <p>UPDATE</p> <p>The print of the bigger tray went well, but took about 39,5 hours to print and a lot of wasted filament because of the support needed. If you dont have a print larger than 223 mm I wont recommend you to print it. Printing the "Buckle" took about 2,5 hours. at 40% infill.</p> <p>Final update</p> <p>In oder to reduce print time and filament use, I had to cut some corners, so I have addet bigtray196 and buckle196 indicate the ca. wide of the parts. This means that the parts nof can be printet without supports and level with my printbed (200,200). This have reduced the print time of the tray to about 7,5 hours.</p> <p>In addition i made a detachable hook.</p> <p>With this I end my devolment of the drain pipe shelf.</p> Category: Bathroom