Draven's Spinning Axes

thingiverse

Draven's spinning axes to be 3D printed! Image preview was printed with 0.16mm layer height. Print inner and outer blades with supports. Part fitting has 0.15mm clearances, make sure your printer is accurate to allow the blades to spin on the handle freely. There is a TestBlade file to check if the blades will fit properly to the handle. I recommend you print this before trying the entire blade. Print two halves of the handle, either with or without the keychain hole, glue them together to form the entire handle. The blades snap on with a firm push and can spin.