Drela AG03 Airfoil Micro Drone Propeller (36.15g thrust @ 3V)

thingiverse

This drone propeller was designed by using the **Drela AG03** airfoil. All tests were done on the **[Drone Propeller Thrust Tester](http://www.thingiverse.com/thing:2302071)** You can inspect the results below. The part was printed with slow speed, with the help of a **[0.2 nozzle](http://amzn.to/2qQdFvg)** at 0.04mm height per layer. Cleaned with the help of an **[X-ACTO Knife](http://amzn.to/2pV1sGA)** After this, I then got to finish the propeller with a small piece of **[400 grit sandpaper](http://amzn.to/2pTNwic)**. These are the readings for a few voltage presets (you can also check these out in the images): - **1.5V** => **10.61 grams** - **2V** => **19.25 grams** - **2.5V** => **28.12 grams** - **3V** => **36.15 grams** The included files contain all pictures relevant to the test, along with 6 txt files that contain airfoil coordinates, the printable STL files and the SLDPRT files. Should you like to use this propeller, make sure you have a couple of **[8520 coreless motors](http://amzn.to/2qPUhi4)**. You should use the SLDPRT files, should you wish to make your own changes to the drone propeller. **Notice:** The airfoil plotted with the matplotlib library for python.