Dremel 395 Holder (V2) for table top or vise

thingiverse

Fits Dremel brand 100 series, 200 series and model 395. Improved? version of http://www.thingiverse.com/thing:822387 Need to hold your Dremel tool in a vise. This holder does. Slides over the 47mm round, 32mm long section. Set into your bench vise and snug it up. Now you have a bench mounted cutoff tool. I could not live without it. Now I don't have to. Holder is 28mm long. Updated version has mounting holes for #8 x 3/4 sheet metal screws and pinch bolt to clamp the Dremel tool. Pinch bolt is #6 x 2. Also need a #6 nut. Available on ebayhttp://www.ebay.com/itm/201369687706?var=&ssPageName=STRK:MESELX:IT&_trksid=p3984.m1558.l2649 Instructions Printed on PrintRBot Plus in about an hour. 2 perimeters, 2 layers top and bottom. Infill at 20%. Oriented with big hole flat to the platform. See photo. Vise mounting does not need the pinch bolt. Run the #6 x 1-1/2 screw thru to clear the hole. Back up screw, drop the nut in and thread screw into nut. Insert Dremel and tighten the screw. Snug the screw. Crank too hard may crush plastic. Flange holes take #8 x 3/4 sheet metal screws. Mount on a 2 x 4, 1 x 4 or anything else. Flange could be C clamped to edge of table.