Drinks Fridge Shelf Clip - 7mm

thingiverse

This is a clip I made for the drinks fridge we have in the office where I work. The rails these clip into have 7mm X 7mm square holes that are spaced about 8mm apart (15mm from the bottom of one hole to the bottom of the next). I do not know how much weight these will hold. I imagine pla is even more brittle in cold, but they don't take very long to print and my PLA test prints seem to work fine so far. I'll probably print them in PETG next if the PLA fails. I printed this on its side so layer adhesion would not be an issue. I did print this with a brim and supports.