Drocon Bugs Drone custom landing feet

thingiverse

I printed [ksztibors](https://www.thingiverse.com/ksztibor) custom folding [landing legs](https://www.thingiverse.com/thing:3515216) (which themselves are based on [Yeps design](https://www.thingiverse.com/thing:3098133)) so I could fit my Go Pro under my drone without it touching the ground. I purchased Carbon Fiber 4mm rods for the legs, but didn't want to sink them into the ground when I landed. I designed these little soft feet and printed them with TPU. They are a perfect fit on the 4mm rods, no adhesive required- they slide right on and stay put. I might revise the angle of the bottom because it messes with my OCD and they are not perfectly flush- but they work great as is. Anyway- if you printed the folding landing legs and got the 4mm rods in fiberglass or CF, these work great. They were printed with 10% infill, so they weight very little. I did not actually weigh the whole setup, but I would imaging the CF legs, with the folding gear in 100% infill and the rubber feet weigh less than all of the stock landing gear that was on it.