Drone It Yourself Printable Parts V1.0

thingiverse

This is a open project called "Drone it yourself". It allows you to 3d print parts to make a drone, then use everyday objects as the frame. Instructions First, Print these parts 4 x motor_mount – the part that holds the motor 4 x clamp.stl – the main body of the clamp 4 x clamp_bar.stl – the small block that forms the other end of the clamp 4 x bolt_handle.stl – a 1 x box_top.stl 1 x box_bottom.stl Next, get these parts 16 x Plain washer, M3 (4 for each motor) – 189-620 16 x Hex socket cap screw, M3x20mm (4 for each motor) – 293-325 4 or 8 x Wing nut, M4 (1 for each clamp, or 2 if you use the extenders) – 521-850 8 / 16 x Plain washer, M4 (2 for each clamp, or 4 if you use the extenders) – 189-636 4 / 8 x Hex socket cap screw, M4x30mm (1 for each clamp, or 2 if you use the extenders) – 290-118 4 x Hex bolt, M4x60mm (1 for each clamp) – 279-571 4 x Mex nut, M6 (1 for each clamp) – 189-591 Now, Assemble the Clamps That will hold your Propellors, Motors and Electronics (Refere to the Last picture in the slideshow for the assembly) Now, get your electronics 4 x Motor 1 x Propeller kit (2 times left and 2 times right rotating) 1 x Propeller accessory pack 4 x ESC (electronic speed controller) 1 x Radio receiver (with a minimum of four channels) 1 x Flight Controller More coming soon