Drone motor adapter for 1/10 RC

thingiverse

A quick adaptor i made to fit a drone motor into a 1/10 RC buggy, fits any motor thats >28mm tall with diameter of >28mm, if the bell housing is too short it can be scaled vertically without affecting part usability. Uses ~14g of plastic I would recommend over-extruding for this part to improve part strength. To fit; push 2 bolts outwards through the two holes at the end of the bell housing as these will be blocked by the motor later, bolt the motor to the top plate and push motor into the bell housing, screw it to the bell housing with the 6 holes around the edge of the top plate. Attach the gear of your choice to the shaft of the motor then bolt the bell housing into the RC vehicle. All holes are M3 (3mm diameter, I use M3 bolts to secure everything).