Drumstick Tambourine

thingiverse

Add some jingle to your drumming. This is sized to fit on Vater Fusion model sticks but they should fit anything with a 14.5mm diameter. Each pin compresses to slide on two tambourine jingles and then you can open the pin up to keep the jingles on. This isn't a permanent percussive accessory due to the plastic pins not being excessively strong but I played with them for a few hours with no problems. If you're a hard hitter your results may vary. Video of the design and print here: https://youtu.be/z7EKJOaeJP0 Print Settings Rafts: Doesn't Matter Supports: No Post-Printing The pins are obviously the weak point on this. The hex cutout is also designed that way to hopefully grip the stick better than just a circle. Heavy playing or hitting rim will probably result in breaking. I also noticed the stick would start to slip if you put on and take off repeatedly. Some tape above and below the print solved that problem. I also ended up slightly spreading the pins out at the top and adding a drop of hot glue to prevent the jingles from popping off.