Drywall tape reel

thingiverse

Made this to save a little money since I don't have a use for it very often. Instructions Print with no supports unless you have issues. Lowest angles are 46deg aside from small diameter holes which I haven't had problems printing without supports. I left the cylinder that holds the tape solid since it actually took more material after I hollowed it out, but that was with my settings. Settings used (kisslicer) are 2mm skin thickness and 12.5% infill. I printed at 0.2mm layer thickness because it seems to bond a little better but 0.3mm would probably be fine. After it's printed, just find an unused wire coat hanger and cut/bend it to fit through the small holes to hold the tape in the reel.