DRZ400SM Vapor speedo magnet adapter and cable tidy

thingiverse

This is a easy way to mount the electronic speedo from a Trail Tech Vapor onto a DRZ400SM. This will not work on an E or S model unless you have an SM full float brake rotor. The magnet "adapter" simply fits into one of the brake rotor buttons and is held in place by a small press fit and a little superglue. The magnet is the one supplied with the Vapor kit and also gets glued into place. The cable guide replaces one side of the stock mount and uses the original bolts but you must source two M6x1.0 nuts. To mount the speedo sensor mark a line where the bottom of the sensor sits on the fork guard (make sure the magnet is in the center of the sensor or close too) then remove the guard and drill two 4mm holes. Mount with the supplied M4 hardware from the Vapor kit.