DSLR Shoulder Rig

thingiverse

This parts-pack is in WIP state. Files may change without notice. Part list for the basic configuration you will need: clamp_2level (2x) - Clamps secondary rods to the primary ones. clamp_basic (xx) - Basic clamp, every other clamp in this design is based around this. clamp_camerapad (2x) - Used for clamping the camera pad to the secondary aluminium rods. clamp_ring (2x) - Main clamps, used for clamping the secondary, tertiary, quaternary and quinary rods. It's the biggest part in this design, so I made a version that is cut in the middle (clamp_ring_half.stl). mount_camerapad (1x) - Used for mounting the camera to the clamp_camerapad. mount_followfocus (1x) - Used for mounting the motor for the focus control. tensioner_followfocus (1x) - Used to tighten the drivebelt. 3 meter long, 15mm wide aluminium rods and a bunch of M6 hex nuts and bolts. Image description: (rods.png) Rods: Red - Primary rods, they lengh 510mm, used to mount the shoulder pad (not designed yet). Green - Secondary rods, they lengh 250mm, used to mount the camera pad. Blue - Tertiary rods, they lengh 190mm, they're unused at this point of designing, so you don't need to cut them. Yellow - Quaternary rods, they lengh 190mm, used to mount the followfocus motor and the tensioner. White - Quinary rods, they lengh 220mm, used to mount the shotgun mic with a clamp_basic. Clamps: Light Grey - These are double level clamps (clamp_2level.stl). Black - These are the ring shaped clamps (clamp_ring.stl).