Dual 18650 Battery Case

thingiverse

This is a case designed to hold two 18650 sized batteries. It is intended to be closed with 2 magnets (6mm x 3mm). One on the base and one in the lid. I can't stress to people enough that carrying around loose batteries is never a good (or safe idea) and a lot of the cases available don't have much shape to them. I designed this with the maker in mind. There is enough room in the body for you to add your own art or text to make this your own. The magnets I used in this build can be purchased here. They are under $5USD for 100 of them! Shop Link If you have any questions, feel free to ask. If you want, feel free to check out my shop at www.vape3d.com or my Facebook Page at www.facebook.com/vape3d. Print Settings Printer: Flashforge Creator Pro Rafts: No Supports: No Resolution: 0.25 Infill: 15% Notes: Shells: 3 Feel free to lower the resolution or raise the infill based on preference and your printer. Post-Printing Magnet install Put a small bit of epoxy inside the hole on both the base and the lid. Place the 6mm X 3mm magnet and allow for it to cure. Careful not to overdue the epoxy as you will cause the magnet to protude.