Dual 80mm Fan Upgrade for 125w AM3+ Stock Cooler with Copper Heat Pipes

thingiverse

I was unhappy with how warm the VRM heat sink was getting on my inverted ATX motherboard and how noisy the stock 70mm fan was on the heat sink, so I made this. This replaces the plastic shroud and 70mm fan and allows 2x 80mm fans that overhang over the RAM and VRM heat sink to keep everything cool. I used Artic 80mm PWM fans with built in 4pin splitters to retain the PWM control of the factory fan. http://www.amazon.com/ARCTIC-F8-PWM-PST-Controlled/dp/B002KTVFPI They move a lot more air, and are quieter. If your fan and shroud look like the last uploaded picture, then this should fit without issue (as long as your RAM does not stick up too high) Print Settings Printer: Wanhao Duplicator i3 Rafts: No Supports: Yes Resolution: .2mm Infill: 100% Notes: Print with the flat surface down. I needed to have supports to have the tangs come out properly on the part that clips the assembly to the CPU cooler. Printed in PETG