Dual Port USB Power Buck Converter Case

thingiverse

Simple vented case to house a slim dual port USB Power Buck. This is the buck converter I used specifically for this design https://www.amazon.com/B01HM0OT6G Using this in my Creality CR6-SE to power a Raspberry Pi for Octoprint. It is small enough to fit along side the power supply and gave me two USB ports with 5v 3A of power. One for the Pi and another for whatever else I may need later. The lid fits tightly and locks the board in place with the two tabs on either side of the USB port. I used a little glue to make sure the lid didn't fall off being it lives upside down. Installed with a strip of double sided tape to mount it to the side of the compartment. You will probably need a support on the side with the power input window. Add a small support to bridge the upper layers.