Dual Titan Aero for Taz 5

thingiverse

This is a quick and dirty carriage for dual Titan Aero on a modified Taz 5 using Piercet's OpenBuild V-Slot X Upgrade (https://www.thingiverse.com/thing:866604). It may work on an un-modified Taz 5, but I haven't tried it. The actual holder is based on pcsentinel's dual holder (https://www.thingiverse.com/thing:2240611 ). I modified it to screw and heat insert onto a modified Taz 5 X mount which screws onto an Openbuild 20x80 universal gantry. This will allow me to test it on my gantry without removing my entire carriage. My offset settings: Right Extruder: //#define HOTEND_OFFSET_X {0.0, 44.8} // (in mm) for each extruder, offset of the hotend on the X axis //#define HOTEND_OFFSET_Y {0.0, 0.00} // (in mm) for each extruder, offset of the hotend on the Y axis M218 T1 X44.80 Y0.00 BLTouch: //#define X_PROBE_OFFSET_FROM_EXTRUDER 21 // X offset: -left +right [of the nozzle] //#define Y_PROBE_OFFSET_FROM_EXTRUDER -32 // Y offset: -front +behind [the nozzle] //#define Z_PROBE_OFFSET_FROM_EXTRUDER -2.04 // Z offset: -below +above [the nozzle] There is a little gap in the horizontal of the extruder holder and the mount plate. This will allow you to shim the angle a few degrees to straighten your nozzles. I am using 2 different nozzles which are not the exact same length. (Hardened steel e3d and Ruby Olsson) I will add a 30mm adapter plate (30mm_e3dv6_fan_adapter.stl) if you want to re-use the fans you have from the E3d v6 fins, or any other 30mm fan for the filament cooler. Current fans keep hitting the back right corner bed plate. I need to redesign. This was mocked up in Tinkercad, so it's a bit less than pristine. If you can clean it up, please do!