Ducati 998 Seat

grabcad

The monoposto seat. This was created from a digital point scan on the actual seat, so the lower and outer edges are within +/- 1 mm. But the front section of this seat is fully padded, and a point scan is quite difficult on soft padding, so here it's within +/- 2 mm. The mounts and lower support pads were also created from the point scan, and they are within +/- 1 mm. The seating area itself was not scanned, so here it's a bit more approximated. And please note that the real seat is quite flexible, so it needs support on the outer edges and especially on the rear section.