Duct Tape holder

thingiverse

This duct tape holder prints without needing supports or rafts, is flexible enough to let the duct tape in through the flared edges, but is sturdy enough to not let it fall out even if held on its side. You may also try to use it as a filament holder if scaled up, but I cannot guarantee it will work. I included the C4D file if anybody wants to customize it, just add it as a remix. Print Settings Printer Brand: Robo 3D Printer: R1 ABS + PLA Model Rafts: No Supports: No Resolution: I used 0.3, but doesn't matter Infill: .25 Notes: Should work with lowest printer settings, its very large and low-detail. Took me just under 4 hours. Post-Printing Step 1: Use Use your duct tape holder Step 2: Something about work Idk ???????? ?????? Step 8: Profit $ $ Bills yall