Duet Rotating Magnet Filament Monitor Mount for Railcore II 300ZL

thingiverse

This is a simple mount for the Duet3D Filament Monitor: Rotating Magnet Version. Docs on the filament sensor can be found here. https://duet3d.dozuki.com/Wiki/Duet3dFilamentMonitor_RotatingMagnetVersion This mounts the monitor on the edge of the printer at the end of the PTFE tube feeding to the extruder. This position was chosen because the wiring to the filament monitor is extremely sensitive to interference from the wiring of a stepper motor. This was the only position I could think of that would not result in the wiring getting run along side a stepper wire. Prints with supports although you might not need them. The support I printed with was just to help out the fillet I have on one of the downward facing corners. Requires 2x 20mm M3 screws and nuts to attach the monitor to the mount and 2x 8mm M3 screws and nuts to attach to the upper extrusion on the printer.