Duet WiFi Ultimaker 2 Power Connector and Duet WiFI Board mount

thingiverse

This is an attempt to combine my Ultimaker 2 power connector housing (which doesn't require a PCB) and the work done by ddt154 to mount a the Duet WiFi board on the bottom of the Ultimaker 2. The mount designed by ddt154 has been heavily modified using a combination of both blender and sketchup. The intent was to mount the Duet Wifi board closer to the base as shown in the pictures to allow for easier access to connectors. As this is based on modifying STL files, and not an original CAD design some of the mesh could be better optimized. This is used with the following connector: https://eu.mouser.com/datasheet/2/222/KPJX-4S-S-982273.pdf 4x M3 screws and 4x M3 square nuts are required to secure the duet board to the mount, and 4x M3 screws and 4x M3 nuts are required to secure the mount to the bottom of the Ulitimaker 2 frame. This is a work in progress, I would like to work more on my terrible cable management as shown in the spiderweb shown in the picture :) and to design a plastic case to go on the bottom of the Ultimaker while providing a grill like structure for ventilation. There is a also work to do ideally include a power switch and female usb connector (either micro-usb, or full size usb-b) connector in the connector housing at the back of the printer to keep with the original ultimaker 2 design,