Dumpster Fire 2020

thingiverse

This is a remix of a couple of different models. Started with the core Dumpster from https://www.thingiverse.com/thing:950602 and the fire from https://www.thingiverse.com/thing:4041269 and then did some customization to put the Year and a CR2032 LED mount inside. I did not print the lids and changed the side handles to be part of the main model. I did not have great luck with casters and am going to try and print them smaller so that they hopefully fit without having to cut them down to size. Notes: I slice using CURA but found it's less likely to fail if I manually add custom supports at the tops and bottom of the 2's in the 2020. The 0's can also fail so might want to add some supports there but will be harder to remove because the model is fragile at that spot. The fire I printed with low 10% infill and gyroid pattern because I find it hides internal structure in clear objects the best. For the CR2032 mount, I print using supports touching build plate. Once supports removed from the mount, put the long leg of the LED all the way down both holes on the right side and bend the leg up. The short leg of the LED goes down the middle hole and back up through the small hole on the left. Pull the legs tight, bend the legs to fix in place, and cut excess off the LEDS. Slide the CR2032 (flat side down) into the slot and the LED should turn on. Push the CR2032 out of connection with the LED leads to turn off.