Duplicator I3 Controlbox Cover for LCD v2.0

thingiverse

I am attempting again to modify the Front angled cover for my Duplicator I3's control box. This time, I made some additions: a 40mm fan on the bottom side would work best if paired with an extracting air design from the back cover. Recommended screws include four M3x15. I also added a front button for emergency stopping and improved the gap between the original wheel and the print; no additional components are necessary. My modified version follows this setup: PLA at 195°C, 0.3 layer thickness with 30% infill and a printing speed of 50mm/s (+supports enabled). It was completed using my Duplicator I3 in approximately seven hours and twenty minutes. A video demonstration can be found at https://youtu.be/sWB5ZUDnT1Y. Please remember to enable support unless you want your prints displayed on the LCD screen to be incorrect.