Durafly Efxtra FPV and FC pod

thingiverse

This is a FPV pod for the Durafly Efxtra. It features mounting for: - Two 30.5 x 30.5 stacks for electronics - Standard size FPV camera - SMA connector - Antenna tubes - Magnet It's recommended to print the pod upside down. The reason for this is that the curved edge on the underside needs to match accurately with the curves of the fuselage and this print orientation minimises supports. The mounting points for the FC require M3 Hex nuts to be glued inplace; there are 8 in total. The magnet recess is shaped to the magnet included with the plane's FPV tray; this magnet should be glued. This recess is quite deep and it may be beneficial to also put a velcro strip (trimmed to size) on the magnet. If a flight controller is to be mounted in the pod, it is recommended to also put a velcro strap between the fuselage and wing to keep tension on the pod. The reason for this is to improve the mechanical coupling between the flight controller's gyro and the plane's body; if the coupling is poor, it will degrade flight controller stablisation performance.