Dux Centre Flush Toilet Cistern - Bezel surrounding flush buttons in lid (parameterised)

thingiverse

This bezel goes around the twin flush buttons in the lid of the cistern. Somehow it can be flushed down the toilet if you are saddled with a sufficiently talented family http://www.dux.co.nz/bathroom/dux-cisterns-and-pan-pacs printed in ABS, 6.7g . Used 0.25mm layers, as the curved top is very poor otherwise A dab of silicon rubber or holtmelt glue will stop it falling out like the original one did Instructions printed in ABS, 6.7g . Used 0.25mm layers, as the gently curved top is very poor otherwise. Found it is best (for easy of removing support) to print upside down, and break off the support by pressing it way at the inside, rather than from the outside. However if you want a clean melted top surface then print it the right way up. You might want to change LidT=2.7+0.2; //thickness of plastic Lid to suit, as the given value is tight on my printer