Dyson - Dual Attachment Tube Mount

thingiverse

Hey Guys - This is a remix of a remix which is an adapter that allows you to mount two tools / attachments to your portable Dyson vacuum. Initially, I used "Dyson Twin Tube Attachment" model, but experienced issues as it was very difficult to attach to the vacuum as seemed a bit small plus each only lasted a couple of months before breaking. This model *(hopefully)* addresses the issue attachment with the following modifications: - Slightly enlarged the holes for the nut - Added recessed hole for bolt's head - Reinforced area around bolt head As for strength, I printed my most recent one using PETG instead of PLA with the below settings in Cura on my Ender 3 Pro... - Layer Height: 0.28 - Infill: 100% - Temp: 240 *(Slightly higher than usual as should result in better adhesion / strength)* - Speed: 50mm/s - Build Plate Adhesion: Brim - Support: "Tree Support" *(Regular support would work, but been using the experimental Tree a lot recently as faster and requires less material)* ***Even Stronger:** Hopefully, the above will last but if not will probably print at higher layer height with 0.6 nozzle with temp of 245ish.* Hope it helps someone - Thanks!