Dyson Hairdryer Accessory Holder

thingiverse

A very neat way to store your Dyson hairdryer attachments to the wall. Prints in under two hours, suggest 25% infill. No supports required. PLA is fine. To mount the holder you will need four countersunk screws that are steel so that the magnets in the accessories attract to them. Easiest way is to use one of the accessories to test whether the screw will stick to it. Then simply mount the holder using those screws, making sure that the screws remain flush with the top of the holder and are not recessed below the top. You can still get a tight fit to the wall with ease. Dead easy project that looks good on the wall as when the accessories are mounted the holder is virtually invisible.